Discover XMEGA

|

Don't stay behind! Discover new XMEGA from Atmel!
Links:
Atmel accomplished a quantum leap introducing new XMEGA microcontrollers. They are much faster, have more peripherals and their price is reasonable. Some of them are even lower cost than traditional ATmega. Don’t wait any longer. Step ahead to explore these fantastic units and use them to design much better devices.

ATxmega128A3U in DIL64


Let us introduce you to the new ATxmega128A3U development board from Leon Instruments. It is populated with every basic peripheral you need to get started with new XMEGA.


ATxmega128A3U peripherials:
  • 128kB Flash, RAM 8kB, EEPROM 2kB
  • 32MHz at 2.7V
  • 7x UART
  • 3X SPI
  • 2x I2C
  • 7X Timer
  • Full speed USB
  • 12-bit 2Msps ADC
  • 12-bit 1Msps DAC
  • Event system i DMA
  • AES/DES
  • Paraller interface for RAM, FPGA, itp.
  • ...and even more!

DIL64 package


With a X3-DIL64 prototyping module you are free to connect any device with ease and convenience. Plug it into the breadboard, just like any integrated circuit, program it and go! It’s so easy. The board’s dimensions are suited to fit conventional DIL64 packages, and pin order is exactly the same as in a processor’s TQFP64 package. That’s why you can apply this module to your EDA software without creating a new library.


Programming


ATxmega128A3U microprocessor can be programmed three ways:
  • PDI interface - it allows you to download/upload the memory and configure the device setting
  • FLIP bootloader - innovative Atmel’s solution for people who don’t own PDI nor JTAG programmer. Just plug in the usual USB cable and go! It’s the best solution for beginners
  • JTAG interface - although the JTAG connector isn’t present on the board, it’s possible to program and debug the device with the JTAG programmer
To improve the development of your software, we’ve populated the prototyping module with RESET and FLIP buttons. Just press them together to activate FLIP bootloader and you can download your software without a PDI/JTAG programmer. You only need an ordinary USB cable and nothing more!


Free to select the crystal


Don’t like the crystal oscillator hard-soldered to the board without any possibility to change processors clock frequency? Sure! We hate it too! That’s why X3-DIL64 module provides a socket for any oscillator of your choice – just plug it into the socket.


Memory will never run out


The X3-DIL64 prototyping module is populated with a microSD socket to have as much memory as your application requires. The microSD card is connected to the processor via SPI interface. Although you don’t need external memory, there’s a possibility to use SPI pins for any other purpose, because they are available on the edge connectors, similar to other microcontroller’s pins


Power supply

And again, with X3-DIL64 you are free to select the power source:
  • From USB – you can power the module directly from your computer
  • From your programmer – if your PDI programmer supports powering the programmed device, with X3-DIL64 this is also possible
  • From any 5V or 3.3V source – simply, provide power from anything you want!

0 comments :

Post a Comment

Post a comment